8
Remote Control Guide
Programming
Getting Started
During programming, all blinds and shades will jog by
moving slightly down and up. Banded, roller and sheer
shades will both jog and provide an audible beep.
Certain programming functions will affect all blinds
and shades on the selected channel such as – favorite
position, travel limits, operating mode and motor speed.
To program an individual blind or shade: pair to its own
channel or put all other shades into sleep mode, or
disconnect blinds from their batteries. Put shades to
sleep by pressing the programming button for 6 seconds
until the motor jogs x 2. Wake shades by pressing the
programming button for less than 1 second.
Select a Channel
Use channel 0 to control all channels together.
Press the
-
button on the remote to select a lower
channel.
Press the + button on the remote to select a higher
channel.
Hide Unused Channels
Select a channel other than 0, then press and hold
the
-
and + buttons simultaneously until remote
control displays “C” then “15”, then release buttons.
Press the
-
or + buttons until the number of visible
channels needed is shown (between 1 and 15).
Press the
stop button to confirm selection. The
screen will display “o” once to confirm selection.
NOTE: Repeat steps 1-3 to unhide channels.
1
1
2
2
3
To Next Page
