12
Remote Control Guide
Programming
Travel Limits
This procedure will adjust the travel limits on all blinds and
shades assigned to a channel.
Upper and lower travel limits are set at the factory during
production to your order specification. Upon installation,
adjustment of these limits may be necessary to better suit
your needs.
Take care adjusting limits to avoid damage to product.
Lower limits cannot be adjusted on sheer shades.
NOTE: If you exit programming before you finish adjusting the
travel limits, the motor will take the previous limits..
Adjust the Upper Limit
Use the
-
and + buttons to select the appropriate
channel.
Press and hold the
up and
stop buttons
simultaneously for about 5 seconds until the motor
jogs x 1 and/or beeps x 1.
Use the
up and
down buttons to raise the blind
or shade to the desired highest position.
Press and hold the
up and
stop buttons
simultaneously for about 5 seconds until the motor
jogs x 2 and/or beeps x 3.
Adjust the Lower Limit
Use the
-
and + buttons to select the appropriate
channel.
Press and hold the
down and
stop buttons
simultaneously for about 5 seconds until the motor
jogs x 1 and/or beeps x 1.
Use the
up and
down buttons to lower the blind
or shade to the desired lowest position.
Press and hold the
down and
stop buttons
simultaneously for about 5 seconds until the motor
jogs x 2 and/or beeps x 3.
1
1
2
2
3
4
4
3
To Next Page
