12
Remote Battery Replacement
Remote Control Guide
REMOTE BATTERY REPLACEMENT
Replacing the batteries in the remote will not cause the
loss of any shutter programming, including GROUPS and
FAVORITE. The remote uses two alkaline AAA batteries.
To replace the batteries in the remote:
1. Slide open back of battery compartment.
2. Gently lift and remove the old batteries. To remove
batteries use a small screwdriver or fingernail to lift
battery and remove from slot.
3. Insert new batteries, be sure to align correct positive
and negative ends and press into place.
4. Align and replace the back cover onto the backside
of the remote.
NOTE: When the louvers start moving slowly, the batteries
in the shutter itself may need to be replaced. More than
likely the batteries in the remote are just fine.
To Next Page
Loading...
