FLOPPY
!
(continued from page 13)
To format a disk:
1. Follow the instructions on page 11 to
access the Automation Session Library
screen.
2. Press the >>OPTIONS soft button.
3. Insert a disk in the 960L disk drive.
4. Press the FLOPPY! soft button.
5. Select the Format Floppy option.
Backup Session
Stores the selected automation session on the
disk inserted in the 960L disk drive.
To store an automation session on disk:
1. Follow the instructions on page 11 to
access the Automation Session Library
screen.
2. Press the >>OPTIONS soft button.
3. Follow the instructions on page 12 to
use the BANK/CATEGORY and SESSION
controls to select the automation session
to be stored.
4. Insert a disk in the 960L disk drive.
5. Press the FLOPPY! soft button.
6. Select the Backup Session option.
Restore to Session
Restores the automation session stored on the
disk inserted in the 960L disk drive to the
selected session bank location.
To restore an automation session stored on
a disk:
1. Follow the instructions on page 11 to
access the Automation Session Library
screen.
2. Press the >>OPTIONS soft button.
3. Follow the instructions on page 12 to
use the BANK/CATEGORY and SESSION
controls to select the session bank location
in which to restore the automation session.
4. Insert the disk containing the desired
automation session in the 960L disk drive.
5. Press the FLOPPY! soft button.
6. Select the Restore to Session option.
NAME
Pressing the NAME soft button accesses the
text editor shown in Figure 15 on the next
page. The text editor can be used to modify the
name of the currently selected session bank.
Note:
The NAME soft button is only available
when the BANK/CATEGORY control is
selected on the LARC2 display
To modify a session bank name:
1. Follow the instructions on page 11 to
access the Automation Session Library
screen.
2. Press the >>OPTIONS soft button.
3. Follow the instructions on page 12 to use
the BANK/CATEGORY control to select the
session bank to be named or renamed.
4. Press the NAME soft button.
5. Enter the new session bank name using
one of the following methods:
• Type the name on the external
keyboard attached to the LARC2.
• Use the arrow keys or the joystick on
the LARC2 to select the desired
character on the text editor, then
press the ENTER button on the LARC2
to enter that character. Repeat this
process until the entire name has been
entered.
6. Save the new session bank name using
one of the following methods:
• Locate the Enter button on the
external keyboard attached to the
LARC2, then press it twice.
• Use the arrow keys on the LARC2
to select the @@@@ button at the
bottom of the text editor, then press
the ENTER button on the LARC2.
Automation Package Addendum
Lexicon
14