14
Adjusting Parameter Values
For each Reflex effect, several param-
eters have been made available for front
panel control through the DECAY, DELAY,
and FX LVL controls. Control over these
parameters is simple — press PARAM-
ETER/LEARN to select a parameter, then
adjust it with the VALUE knob. All parameter
settings made from the front panel can be
stored with the effect.
The VALUE knob is always active, and will
adjust whichever parameter is indicated by
the display LEDs. The first turn of VALUE will
display the current parameter setting. Sub-
sequent adjustments will increment or dec-
rement parameter values along their entire
range.
The decimal point on the display will light
when a parameter is adjusted to indicate that
the effect has been modified since the last
store operation. If no further adjustments are
made with VALUE, the display will revert to
showing the number of the currently running
effect. The edit indicator will remain on until
the effect is stored, or until changes are lost
by selecting another effect with the REGIS-
TER/PRESET knob.
Editing an Effect
DECAY
DELAY
FX LVL
PARAMETER/LEARNSTORE (+)/CLEAR (–)
VALUE
The decimal point indicates changes have
been made since the last store operation.
Use the VALUE knob to adjust
the selected parameter.
Press PARAMETER/LEARN to toggle selection of one
of the three front panel parameters. A lighted LED
indicates your selection.
Parameter values will be displayed when
VALUE is turned. The parameter LED will
flash to indicate that a parameter value (as
opposed to a preset or register number) is
being displayed.
To Next Page
Loading...
