15
TAP and Echo Rhythms
Storing an Effect
To store the currently running effect:
1. Briefly press STORE/CLEAR until a plus
sign (+) is displayed.
2. Press and hold STORE/CLEAR.
If you were in preset mode, the register
LED will go on, indicating that Reflex has
automatically switched to register mode
— selecting whatever register was last
displayed.
If you want to store to a different reg-
ister than the one displayed, turn the
REGISTER/PRESET knob to the regis-
ter number you want
before
releasing
STORE/CLEAR.
3. Releasing STORE/CLEAR will store the
currently running effect into the register
indicated on the display, overwriting the
effect previously stored there. The dis-
play will flash briefly to indicate the store
operation was successful.
Reflex presets cannot be erased or over-
written by parameter changes; the original
version will always be restored when loaded.
If you make changes to a preset and want to
save the changes as a custom effect, you
must store your new versions into registers.
To Next Page
Loading...
