5
Footswitch Connections
A footswitch connected via the rear-panel
footswitch jack allows you to perform register
STEP and BYPASS functions. Two momen-
tary foot-switches can be wired to a tip-ring-
sleeve connector. A stereo Y-connector al-
lows two identical single switches to be used.
Headphones
A stereo signal which is adequate to drive
high-efficiency headphones is available at
the left output,
provided no connections are
made through the right output
. This feature is
provided as a convenience for practice pur-
poses, and is intended to provide only mod-
est volume.
TIP
RING
SLEEVE
Tip Sleeve
Ring
Bypass
Step
or
TIP
RING
SLEEVE
Tip Sleeve
Ring
Bypass
When shipped, Reflex is configured to use
momentary contact switches. You can change
this configuration to allow the use of latching
switches by performing the following proce-
dure:
1. Simultaneously press the PARAMETER/LEARN
and the REGISTER/PRESET buttons. This will
put the unit into Advanced Programming Mode
(lighting all 3 front panel parameter LEDs).
2. Turn the REGISTER/PRESET knob to 15. The
letter "F" should appear on the display.
3. Turn the VALUE knob to select 0 (latching) or 1
(momentary).
4. Press the REGISTER/PRESET button to re-
store normal front panel operation.
BYPASSSTEP
A dual-function footswitch is available from
Lexicon. A set of labels to identify footswitch
functionality is included with your unit.
To Next Page
Loading...
