EasyManua.ls Logo

Lexington Forge CONCORDE C28DV - Log Placement

Lexington Forge CONCORDE C28DV
40 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
24 45D0028
45D0028 25
LOG PLACEMENT
INSTALLING LOGS AND ROCK WOOL (EMBER MATERIAL) IN FIREBOX
1. Carefully remove logs from wrapping.
2. Open front door of rebox.
3. Place rear log against back of rebox. See Figure 31.
4. Place left base log on the two pins against left side of rebox. See Figure 32.
Figure 31 -
Installing Rear Log
Before you begin This unit is supplied with six ceramic ber logs. Do not handle these logs with your bare hands.
Always wear gloves to prevent skin irritation from ceramic bers. After handling the logs, wash your hands gently with
soap and water to remove any traces of bers.
The positioning of the logs is critical to the safe and clean operation of this heater.
Sooting and other problems may result if the logs are not properly and firmly positioned
in the appliance. Never add additional logs or embellishments such as pine cones or
vermiculite to the heater. Only use the logs supplied with the unit.
Failure to position the parts in accordance with diagrams below or to use only parts
specifically approved for this heater may result in property damage or personal
injury.
WARNING
Continued on next page
Figure 32 - Installing Left
Base Log
Rear Log
Left Base
Log
Grate Grate

Related product manuals