EasyManua.ls Logo

Lexington Forge CONCORDE C28DV - Product Features; Code Approval; Product Specifications

Lexington Forge CONCORDE C28DV
40 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
4 45D0028
45D0028 5
PRODUCT FEATURES AND CODE APPROVAL
Pilot
Data and
Instruction
Plates
Optional
Remote
Receiver
Door
Figure 1 - Cast Iron Stove
This appliance has been certi-
ed for use with either natural or
propane gas. See appropriate data
plates.
This appliance is not for use with
solid fuels.
The appliance is approved for
bedroom or bedsitting room
installations.
The appliance must be installed
in accordance with local codes if
any. If none exist use the current
installation code. ANSI Z223.1/
NFPA 54 in the USA, CAN/CGA
B149 in Canada.
This appliance is mobile home
approved.
The appliance must be properly
connected to a venting system.
The appliance is not approved for
closet or recessed installations.
For alcove installation see
“Clearances,” page 8.
Hi/Lo
Knob
PRODUCT SPECIFICATIONS
The efciency rating of this appliance is
a product thermal efciency rating deter-
mined under continuous operating condi-
tions and was determined independently of
any installed system.
Thermal Efciency = up to 80%
CODE APPROVAL
Direct Vent type appliances draw all combustion air from outside of the dwelling through the vent pipe.
These appliances have been tested by CSA and found to comply with the established standards for DIRECT VENT GAS
FIREPLACE HEATERS in the USA and Canada as follows:
LISTED VENTED GAS FIREPLACE HEATER
TESTED TO: ANSI Z21.88b-2001/CSA 2.33b-2001 STANDARDS
On/Off
Switch
Ignitor
Battery
Pack

Related product manuals