Adjusting the fax darkness
Note: Make sure that fax is
configured.
For more information, see “Setting up the printer to fax” on page 64.
1 Load an original document into the ADF tray or on the scanner glass.
2 From the home screen, touch Fax, and then enter the needed information.
3 Tou ch Darkness, and then adjust the setting.
4 Send the fax.
Printing a fax log
Note: Make sure that fax is configured. For more information, see “Setting up the printer to fax” on page 64.
1 From the home screen, touch Settings > Reports > Fax.
2 To uc h Fax Job Log or Fax Call Log.
Blocking junk faxes
Note: Make sure that fax is configured. For more information, see “Setting up the printer to fax” on page 64.
1 From the home screen, touch Settings > Fax > Fax Setup > Fax Receive Settings > Admin Controls.
2 Set Block No Name Fax to On.
Holding faxes
Note: Make sure that fax is
configured.
For more information, see “Setting up the printer to fax” on page 64.
1 From the home screen, touch Settings > Fax > Fax Setup > Fax Receive Settings > Holding Faxes.
2 Select a mode.
Forwarding a fax
Note: Make sure that fax is
configured.
For more information, see “Setting up the printer to fax” on page 64.
1 Create a destination shortcut.
a From the home screen, touch Shortcut Center.
Note: The icon and name may have been changed. For more information, contact your administrator.
b Select a printer function, and then touch Create Shortcut.
c Configure the settings, and then touch Save.
d Type a unique shortcut name.
e To uc h OK.
Note: Take note of the shortcut number.
2 From the home screen, touch Settings > Fax > Fax Setup > Fax Receive Settings > Admin Controls.
Faxing 74
To Next Page
Loading...
