Removing memory and option cards
25
Installing and removing options
Removing an “option-added” firmware card
Warning: Optional “option-added” firmware cards are easily damaged by static electricity. Touch something
metal on the printer before you touch an optional firmware card.
1 Remove the system board access cover. For more information, see Accessing the printer system board.
2 Grasp the “option-added” firmware card gently, and pull it straight out in one motion. Do not pull one side and then
the other.
3 Place the card in its original packaging, or wrap the card in paper and store it in a box.
Reinstalling the system board access cover
1 Align the slots at the top of the access cover with the screws near the top of the printer.
2 Slide the cover up under the top cover lip as far as it will go, and then tighten the screws at the top of the cover.
3 Insert and tighten the four screws to the bottom of the cover.
4 Reconnect all cables on the back of the printer.
5 Plug in the printer power cord.
6 Turn the printer on.
To Next Page
Loading...
