Aligning the optional finisher
37
Installing and removing options
Aligning the finisher with the printer
The following three areas must align properly to prevent paper jams.
1 The docking plate pins must enter the holes in the finisher.
2 The space between the printer and finisher must be the same at the top and bottom of the finisher.
3 The alignment marks on top of the finisher must align with the edges of the cover on the side of the printer.
4 Roll the finisher toward the printer until the finisher locks to the docking plate pins.
You hear a click when the finisher locks into position.
If the pins did not go into the holes in the finisher, see Lowering or raising the finisher. Otherwise, go to
Aligning the sides of the finisher.
Hole in
finisher
Docking plate pin
Spacing
Alignment marks
Downloaded From ManualsPrinter.com Manuals
To Next Page
Loading...
