Lexmark C920 - Loading Standard Trays and Optional Trays

Loading standard trays and optional trays
60
Printing
Loading standard trays and optional trays
Your printer has a 550-sheet standard tray. You may have also purchased one or more 550-sheet optional trays. The steps
for loading a standard or optional tray are the same.
Note: The steps for loading an optional high capacity feeder are different than the steps for loading a 550-
sheet tray.
To load print media:
Note: Do not remove a tray when a job is printing or when the operator panel indicator light is blinking. Doing
so may cause a jam.
1 Open the tray.
2 Squeeze the side guide tab, and position the guide for the size media you are using.
3 Flex the sheets back and forth to loosen them, then fan them. Do not fold or crease the print media. Straighten the
edges on a level surface.
4 Place the print media face down in the tray. For duplex (two-sided) printing on letterhead, place the print media
face up in the tray.
Note: Do not fill paper above the load line. Overfilling the tray may cause jams.
5 Squeeze the front guide tab, and slide the guide toward the inside of the tray until it lightly rests against the edge
of the media.
Downloaded From ManualsPrinter.com Manuals