Lexmark CS410 Technical Reference Manual

Deviations
169
reading equipment may be capable of decoding data in excess of the maximum allowed in the AIM
MaxiCode specification.
Bar code horizontal alignment
Certain UPC and EAN bar codes may not start at the existing PCL cursor position, but may be
shifted to the right up to 3–4 mm on the left side, and up to 2 mm on the right side. This is due to the
presence of start characters, which may or may not shift the bar code (and HRT) to the right.
If a customer allocates space for these particular bar codes, and they do not fit on the right side, then
there are two options:
• Use the PCL “B” and “S” parameters to slightly shrink the bar code in size.
• Escalate it for a field fix.
PDF417 capacity
The Introduction of the AIM PDF417 specification defines the Maximum Data Characters per symbol
(at ECC0) for PDF417:
• 1850 text characters
• 2710 digits
• 1108 bytes
Section 2.1 states:
• "The total number of codewords in the data region of a single PDF417 symbol cannot exceed
928".
All input data should conform to the AIM PDF417 specification, and any input data over the
maximum lengths should be truncated and discarded. A maximum of 2710 digits or 1850 text
characters should be allowed and truncated by firmware before the BCE is called.
The remaining maximum data should be safely submitted to the BCE to be rendered. This will
require extra checking code to be added before the BCE, to truncate any excess data. However, this
procedure will prevent the BCE from throwing errors on pages with excess data, while encoding as
much of that data as possible.
The original LXK BCC will encode more than the maximum amount allowed by the AIM specification,
but users should never exceed these values. If users were to change to other printing equipment that
did not tolerate a marginally higher capacity, then their process will be broken. Also, not all bar code
reading equipment may be capable of decoding data in excess of the maximum allowed in the AIM
PDF417 specification.
MaxiCode separators and structured appends
Note: For more information, see the AIM MaxiCode specifications.
A valid MaxiCode data separator for MaxiCode data blocks is either:

Lexmark CS410 Specifications

General

Print Technology	Color Laser
Print Resolution	1200 x 1200 dpi
Standard Memory	256 MB
Processor Speed	800 MHz
Standard Input Capacity	250 sheets
Connectivity	USB, Ethernet
Supported Operating Systems	Windows, Mac OS, Linux
Monthly Duty Cycle	75, 000 pages
Maximum Memory	2304 MB
Duplex Printing	Yes
Mobile Printing	Yes