Error codes Error message Solution
58 Too many trays attached.
Only <x/> tray/s can be
supported.
1 Turn o the printer.
2 Unplug the power cord from the
electrical outlet, and then from
the printer.
3 Remove one or more trays.
4 Connect the power cord to the
electrical outlet, and then turn on
the printer.
CAUTION—POTENTIAL
INJURY: To avoid the risk of fire or
electrical shock, connect the power
cord to an appropriately rated and
properly grounded electrical outlet
that is near the product and easily
accessible.
59 Incompatible tray [x].
1 Turn o the printer.
2 Unplug the power cord from the
electrical outlet, and then from
the printer.
3 Remove the indicated tray.
4 Connect the power cord to the
electrical outlet, and then turn on
the printer.
CAUTION—POTENTIAL
INJURY: To avoid the risk of fire or
electrical shock, connect the power
cord to an appropriately rated and
properly grounded electrical outlet
that is near the product and easily
accessible.
61 Remove defective disk. Replace the defective storage drive.
62 Disk full. Try one or more of the following:
• To uc h Continue to clear the
message.
• Delete fonts, macros, and other
data stored in the intelligent
storage drive.
• Install an intelligent storage drive.
Troubleshoot a problem 244
To Next Page
Loading...
