Lexmark E 250d - Font Error; Insufficient Printer Memory

31
Understanding the control panel lights
Font error
Insufficient printer memory
Light sequence:
• Continue—On
• Toner Low/Replace PC Kit—Blinking
• Error—On
What this light sequence means:
The printer has received a request for a font (PPDS) which is not
installed.
What you can do:
• Press and release Cancel to cancel the print job.
• Press and hold Cancel to reset the printer.
• Press Continue to clear the message and continue
printing.
Light sequence:
• Continue—On
• Load Paper—Blinking
• Error—On
What this light sequence means:
The printer does not have enough memory to save the data in the
buffer.
What you can do:
• Install additional memory (see Adding a memory card
on page 72).
• Press Continue to continue printing the job.
• Press Cancel to cancel the print job.