72
Adding a memory card
Adding a memory card
The system board has one connector for an optional memory card. The printer can support up to 64MB of additional
memory (for a total of 80MB).
Memory options designed for other Lexmark printers may not work with your printer.
1 Access the system board (see Accessing the system board on page 69).
2 Push open the latches on both ends of the memory
connector.
3 Unpack the memory card.
Warning: Memory is easily damaged by static electricity.
Touch something metal, such as the printer
frame, before you touch a memory card.
Avoid touching the connection points along the edge of the
card.
4 Align the notches on the bottom of the card with the notches
on the connector.
5 Push the memory card firmly into the connector until the
latches on either end of the connector snap into place.
Some force may be required to fully seat the card.
6 Make sure each latch fits over the notch on each end of the
card.
7 Close the side door.
8 Close the rear exit.
9 Close the front door.
10 See Recognizing installed options on page 73.
CAUTION: If you are installing a memory card after setting up the printer, turn the printer off,
and unplug the power cord from the wall outlet before continuing.
To Next Page
Loading...
