A.10
When selecting labels, consider the quality of each
component:
• Adhesives: The adhesive material should be stable at
200 °C (392 °F), the printer fusing temperature.
• Arrangement: Only use labels with no exposed backing
between them. Labels can peel off sheets with spaces
between the labels, causing serious jams.
• Curl: Prior to printing, labels must lie flat with no more
than 13 mm (.5 in.) of curl in any direction.
• Condition: Do not use labels with wrinkles, bubbles, or
other indications of separation.
See “Printing on Labels” on page 4.16.
Transparencies used in the printer must be able to
withstand 200 °C (392 °F), the printer fusing temperature.
See “Printing on Transparencies” on page 4.18.
Warning!
• To avoid damaging the printer, use only labels
recommended for laser printers.
• To prevent serious jams, always use the face-up
output slot.
• Never print on the same sheet of labels more than
once or print on a partial sheet of labels.
Guidelines for Using Labels
Guidelines for Using Transparencies
Warning! To avoid damaging the printer, use only
transparencies recommended for use in laser printers.
Print Media Specifications
DRIVER AND PRINTER SPECIFICATIONS
To Next Page
Loading...
