4.16
USING PRINT MEDIA
Printing on Labels
Guidelines
• Only use paper labels recommended for laser printers.
• Verify that the label adhesive material can tolerate fusing temperature of 200°C
(392°F) for 0.1 second.
• Make sure that there is no exposed adhesive material between the labels. Exposed
areas can cause labels to peel off during printing, which can cause paper jams.
Exposed adhesive can also cause damage to printer components.
• Do not feed a sheet of labels through the printer more than once. The adhesive
backing is designed for one pass through the printer.
• Do not use labels that are separating from the backing sheet or are wrinkled,
bubbled or otherwise damaged.
2 Push the guide against the stack of
labels without bending it.
1 Load the labels in the input tray you
want to use with print side up.
Note: Up to five sheets of labels can
be loaded in the automatic input
tray. The manual input tray holds
only one sheet at a time. A
manually-loaded sheet is shown.
To Next Page
Loading...
