When you select Manual for Paper Source from your
software application, you should press each time
you load a sheet of paper manually. For further
information, see “Using the Manual Input tray” on page
4.8.
3.3
Control Panel Buttons
Press and hold until the control panel lights blink to
cancel a job the printer is currently printing. The light
blinks while the print job is cleared from both the printer
and the computer, and then returns to the Ready mode.
This may take some time, depending on the size of the
print job.
Note: If the button is accidentally pushed, the job
must be reprinted. There is no undo function.
Canceling a job
USING THE CONTROL
Manual feeding
To Next Page
Loading...
Need help?
General