Using memory cards and flash drives
Using a memory card or flash drive with the printer
Insert a memory card into the card slot or a flash drive into the USB port.
Inserting a memory card Inserting a flash drive
M
E
M
O
R
YS
T
I
C
K
Notes:
• Insert the card with the brand name label facing up.
• Make sure any arrows on the card point toward the
printer.
• If necessary, connect the memory card to the adapter
that came with it.
• Make sure that the memory card inserted is supported
by the printer. For more information, see “Supported
memory cards and file types” on page 23.
F
L
A
S
H
D
R
I
V
E
Notes:
• The flash drive uses the same port that is used for a
PictBridge camera cable.
• An adapter may be necessary if your flash drive does not
fit directly into the port.
Warning—Potential Damage: Do not touch any cables, any network adapter, any
connector, the memory device, or the printer in the areas shown while actively printing,
reading, or writing from the memory device. A loss of data can occur.
The Memory Device screen appears on the display.
Notes:
• If the printer does not recognize the memory device, then remove and reinsert a supported one.
• If a flash drive or a digital camera set to mass storage mode is inserted into the USB port while a memory card is
in the card slot, then a message appears on the display prompting you to choose which memory device to use.
About your printer
22
To Next Page
Loading...
