Adjusting the fax darkness
Note: Make sure that fax is
configured.
For more information, see “Setting up the printer to fax” on page 24.
1 Load an original document into the ADF tray or on the scanner glass.
2 From the home screen, touch Fax, and then enter the needed information.
3 Tou ch Darkness, and then adjust the setting.
4 Send the fax.
Printing a fax log
Note: Make sure that fax is configured. For more information, see “Setting up the printer to fax” on page 24.
1 From the home screen, touch Settings > Reports > Fax.
2 To uch Fax Job Log or Fax Call Log.
Blocking junk faxes
Note: Make sure that fax is configured. For more information, see “Setting up the printer to fax” on page 24.
1 From the home screen, touch Settings > Fax > Fax Setup > Fax Receive Settings > Admin Controls.
2 Set Block No Name Fax to On.
Holding faxes
Note: Make sure that fax is
configured.
For more information, see “Setting up the printer to fax” on page 24.
1 Open a web browser, and then type the printer IP address in the address field.
Notes:
• View the printer IP address on the printer home screen. The IP address appears as four sets of
numbers separated by periods, such as 123.123.123.123.
• If you are using a proxy server, then temporarily disable it to load the web page correctly.
2 Click Settings > Fax > Fax Setup > Fax Receive Settings > Holding Faxes.
3 Select a mode.
4 Apply the changes.
Forwarding a fax
Note: Make sure that fax is configured. For more information, see “Setting up the printer to fax” on page 24.
1 Create a destination shortcut.
a Open a web browser, and then type the printer IP address in the address field.
Fax 68
To Next Page
Loading...
