Error code Description Action
332.56 Motor 2 (Separator/Passthru) PWM underflow
(motor overspeed)
Go to
“Option tray separator/pass through motor
service check” on page 117.
334.57 Motor 3 motor no first encoder Go to
“Option tray ACM motor service check” on
page 118.
334.58 Motor 3 motor stop error Go to
“Option tray ACM motor service check” on
page 118.
334.59 Motor 3 PWM underflow (motor overspeed) Go to
“Option tray ACM motor service check” on
page 118.
335.60 Hardware error—Board ID unknown Go to
“Option tray controller card service check” on
page 118.
335.61 Hardware error—Option type unknown Go to
“Option tray controller card service check” on
page 118.
335.62 Hardware error—Product ID unknown Go to
“Option tray controller card service check” on
page 118.
335.63 Hardware error—Sensors are not plugged on the
board.
Go to
“Option tray controller card service check” on
page 118.
341.51 Motor 1 (Pick/Lift) motor no first encoder Go to
“Option tray pick/lift motor service check” on
page 117.
341.52 Motor 1 (Pick/Lift) motor stop error Go to
“Option tray pick/lift motor service check” on
page 117.
341.53 Motor 1 (Pick/Lift) PWM underflow (motor
overspeed)
Go to
“Option tray pick/lift motor service check” on
page 117.
342.54 Motor 2 (Separator/Passthru) motor no first encoder Go to
“Option tray separator/pass through motor
service check” on page 117.
342.55 Motor 2 (Separator/Passthru) motor stop error Go to
“Option tray separator/pass through motor
service check” on page 117.
342.56 Motor 2 (Separator/Passthru) PWM underflow
(motor overspeed)
Go to
“Option tray separator/pass through motor
service check” on page 117.
344.57 Motor 3 motor no first encoder Go to
“Option tray ACM motor service check” on
page 118.
344.58 Motor 3 motor stop error Go to
“Option tray ACM motor service check” on
page 118.
344.59 Motor 3 PWM underflow (motor overspeed) Go to
“Option tray ACM motor service check” on
page 118.
4514
Diagnostic information
116
To Next Page
Loading...
