Cartridge gearbox removal
1 Remove the left cover. See “Left cover removal” on page 168.
2 Remove the four screws (A) securing the cartridge gearbox.
A
3 Disconnect the cable from the cartridge gearbox.
Duplex gear assembly removal
1 Remove the left cover. See “Left cover removal” on page 168.
2 Remove the rear door and cover. See “Rear door and cover removal” on page 232.
3 Remove the power supply. See “Power supply removal” on page 216.
4 Remove the power supply shield. See “Power supply shield removal” on page 217.
5 Remove the duplex. See “Duplex removal” on page 218.
6 Position the printer so that it sits on its right side.
7 Remove the E‑clip (A).
8 Remove the screw (B).
9 Remove the screw (C).
4514
Repair information
183
To Next Page
Loading...
