Complex page, some data may not have printed [39]
Try one or more of the following:
• From the printer control panel, press to clear the message and continue printing.
• Reduce the number and size of fonts, the number and complexity of images, and the number of pages
in the print job.
• Cancel the print job.
• Install additional printer memory.
Configuration change, some held jobs were not restored [57]
From the control panel, press to clear the message and continue printing.
Defective flash detected [51]
Try one or more of the following:
• Replace the defective flash memory card.
• From the printer control panel, press to ignore the message and continue printing.
• Cancel the current print job.
Incorrect paper size, open [paper source] [34]
Note: The paper source can be a tray or a feeder.
Try one or more of the following:
• Load the correct size of paper in the paper source.
• From the control panel, press to clear the message and print using a dierent paper source.
• Check the length and width guides of the paper source and make sure the paper is loaded properly.
• Make sure the correct paper size and type are specified in the Printing Preferences or in the Print dialog.
• Make sure the paper size and type are specified in the Paper menu on the control panel.
• Make sure that the paper size is correctly set. For example, if Multipurpose Feeder Size is set to
Universal, then make sure the paper is large enough for the data being printed.
• Cancel the print job.
Insucient memory to support Resource Save feature [35]
Try one or more of the following:
• From the printer control panel, press to disable Resource Save, clear the message, and continue
printing.
• Install additional printer memory.
Troubleshooting 147
To Next Page
Loading...
Need help?
General
