Lexmark MS510 - Page 17

2 Lightly press the stop on the left side of the controller board access door, and then slide the access door to remove.
3
1
2
3 Unpack the ISP kit.
Note: Make sure to remove and discard the small cable attached to the white connector.
1
2
4
3
5
6
1 ISP solution
2 Screw to attach the ISP solution to the plastic bracket
3 ISP exterior cover
4 Screws to attach the ISP solution to the ISP exterior cover
5 Plastic bracket
6 Long ISP cable
Additional printer setup 17