13 Close the controller board shield.
14 Close the ISP exterior cover.
Note: When the printer software and any hardware options are installed, you may need to manually add the options
in the printer driver to make them available for print jobs. For more information, see “Updating available options in
the printer driver” on page 28.
Installing a printer hard disk
Note: This option is available only in MS610de printer model.
CAUTION—SHOCK HAZARD: If you are accessing the controller board or installing optional hardware or
memory devices sometime after setting up the printer, then turn the printer off, and unplug the power cord
from the electrical outlet before continuing. If you have any other devices attached to the printer, then turn
them off as well, and unplug any cables going into the printer.
Warning—Potential Damage: Controller board electronic components are easily damaged by static electricity.
Touch something metal on the printer before touching any controller board electronic components or connectors.
1 Access the controller board.
For more information, see “Accessing the controller board” on page 73
Note: This task requires a flathead screwdriver.
2 Unpack the printer hard disk.
3 Install the printer hard disk on the controller board:
Warning—Potential Damage: Hold only the edges of the printed circuit board assembly. Do not touch or press
on the center of the printer hard disk. Doing so may cause damage.
Additional printer setup 22
To Next Page
Loading...
