Scenario 4: Digital telephone service through a cable provider
Setup 1: Printer is connected directly to a cable modem
1 Connect one end of the telephone cable that came with your printer to the port of the printer.
2 Connect the other end of the cable to the port labeled Phone Line 1 or Phone Port on the cable modem.
Note: The port labeled Phone Line 2 or Fax Port is not always active. VoIP providers may charge additional cost
for activation of the second phone port.
3 Connect your analog telephone phone to the port of the printer.
Notes:
• To make sure that the telephone port on the cable modem is active, plug an analog telephone into the
telephone port, and then listen for a dial tone. If you hear a dial tone, then the port is active.
Faxing 135
To Next Page
Loading...
