Lexmark MX810 Series - Solving Printer Problems

Unsupported camera mode, unplug camera and change mode
The camera mode does not support PictBridge.
Unplug the camera, change the mode and plug the camera back into the printer.
Unsupported disk
Remove the unsupported printer hard disk, and then insert a supported one.
Unsupported option in slot [x] [55]
1 Turn off the printer.
2 Unplug the power cord from the electrical outlet.
3 Remove the unsupported option card from the printer controller board, and then replace it with a supported card.
4 Connect the power cord to a properly grounded electrical outlet.
5 Turn the printer back on.
USB port [x] disabled [56]
From the printer control panel, touch Continue to clear the message.
Notes:
• The printer discards any data received through the USB port.
• Make sure the USB Buffer menu is not set to Disabled.
Weblink server not set up. Contact system administrator.
From the printer control panel, touch Continue to clear the message.
Note: If the message appears again, then contact your system support person.
Solving printer problems
• “Basic printer problems” on page 319
• “Hardware and internal option problems” on page 321
• “Paper feed problems” on page 324
Troubleshooting 318