b
If the A5 length guide is still attached, then remove it. If the
guide is not attached, then proceed to
step d on page
12.
c
Place the A5 length guide in its holder.
d
Squeeze, and then slide the length guide to the correct
position for the size of the paper being loaded.
3
Flex, fan, and align the paper edges before loading.
4
Load the paper stack with the printable side facedown.
•
Load letterhead depending on whether an optional staple
finisher is installed or not.
Without an optional staple
finisher
With an optional staple finisher
One‑sided printing One‑sided printing
Two‑sided printing Two‑sided printing
•
When loading prepunched paper, make sure that the holes
on the long edge of the paper are against the right side of
the tray.
One‑sided printing Two‑sided printing
5
Insert the tray.
Note: Press down the paper stack while inserting the tray.
12
To Next Page
Loading...
