14
Install memory cards
1 Align the six keyholes on the
shield with the six screws on the
system board.
2 Press the shield against the
system board, and then slide the
shield to the right.
3 Tighten the six screws.
Reattaching the
side cover
1 Align the three rear tabs on the
side cover with the corresponding
slots on the printer.
2 Guide the tabs on the top, bottom,
and front of the cover into their
corresponding slots.
The top and front tabs snap into
place.
3 Close the upper front door and the
multipurpose feeder door.
Make sure both doors snap closed
on both sides.
To Next Page
Loading...
