4
Position the optional drawer
Step 2: Position the optional
drawer
CAUTION! If you are adding an
optional drawer sometime after setting
up the printer, be sure to turn the printer
off, unplug the power cord, and
disconnect all cables from the back of
the printer before completing these
tasks.
Your printer supports either one optional
250-sheet drawer or one optional 500-
sheet drawer. The optional drawer
consists of a support unit and a tray.
1 Remove all packing material and
tape from the support unit.
2 Pull the tray out of the support
unit.
Remove any packing material and
tape from the tray.
3 Grasp the support unit on each
side at opposite corners and
move it to the location selected for
the printer.
4 Reinstall the tray. Push it fully into
the printer.
To Next Page
Loading...
