6 Flip the hard disk over, and then press the three posts on the mounting plate into the holes on the system board.
The hard disk snaps into place.
7 Reinstall the system board.
Replacing the access panel
After you have installed options on the printer system board, follow these steps to reattach the access panel.
Note: This operation requires a #2 Phillips screwdriver.
1 Align the tabs on the right side of the access panel with the slots on the printer.
2 Slide the panel to the right, and then push it towards the printer.
1
2
Additional printer setup 23
To Next Page
Loading...
