Linking exit bins
The standard exit bin holds up to 500 sheets of 64–216 g/m
2
(17–58 lb) paper, depending on the printer model. If you
need additional output capacity, you can purchase other optional exit bins.
Note: Not all exit bins support every paper size and type.
Linking exit bins lets you create a single output source so the printer can automatically switch output to the next available
exit bin.
1 Make sure the printer is on and Ready appears.
2 From the printer control panel, press .
3 Press the up or down arrow button until Paper Menu appears, and then press .
4 Press the up or down arrow button until Bin Setup appears, and then press .
5 Press the up or down arrow button until the correct tray appears, and then press .
6 Press the up or down arrow button until Configure Bins appears, and then press .
7 Press the up or down arrow button until Link appears, and then press .
Assigning a Custom Type <x> name
Assign a Custom Type <x> name to a tray to link or unlink it. Associate the same Custom Type <x> name to each tray
that you want to link. Only trays with the same custom names assigned will link.
1 Make sure the printer is on and Ready appears.
2 From the printer control panel, press .
3 Press .
The Paper Menu appears.
4 Press .
The Paper Size/Type menu appears.
5 Press the down arrow button once.
appears next to the name of the tray.
6 Press .
The Paper Size menu appears.
7 Press again.
The Paper Type menu appears.
Loading paper and specialty media 55
To Next Page
Loading...
