display on all printers. Selecting Physical Page on a printer which does not support
edge to edge allows the first print position to be located at the edge of the media.
This allows print position compatibility with printers which support edge to edge
printing. The print image will be clipped to the printable area supported by the
printer when edge to edge printing is not supported.
Note: The Lexmark C792, Lexmark X792 and Lexmark 6500e printers can
physically print edge to edge.
The job is formatted for a page using a printable area of edge to edge. When the
page is printed, the page image is compressed approximately 2% in both the
horizontal and vertical directions and is centered on the page. Full page printing is
not supported on all printers.
Note: The Lexmark C792, Lexmark X792 and Lexmark 6500e printers support
the Full Page print mode.
The printable area for the media loaded is reported to the host. A printable area that
more closely matches the values reported by the IBM 4028 printer is reported.
Clipping occurs if data is printed outside the printable area. All four edges will be
clipped.
The printable area for the media loaded is reported to the host. A printable area that
more closely matches the values reported by the IBM 4028 printer is reported. If
the logical page is outside the printable area it is moved down and to the right. The
right and bottom edges will be clipped.
3.3.11 Exception Control
It is often practical to suppress exception reporting on undefined characters and on position errors
(printing outside the valid printable area, VPA). This option overrides the Exception Handling Control
in the IPDS data stream.
No suppression of exceptions. Exception reporting is controlled by the IPDS data
stream.
Exception reporting on position errors (outside VPA) is suppressed. The printer
IPDS emulation will print the IPDS job but not report "08C1" printable area
exceptions or "0411" bar code exceptions to the host.
If an undefined character is found, exception reporting is suppressed. The printer
IPDS emulation will print the IPDS job but not report "0821" undefined character
exceptions to the host.
Both position errors and undefined character exceptions are suppressed.
To Next Page
Loading...
