Lexmark X548 - Remove User Files

28
3.4.12.2 Instruction CC
CC CMRs contains ICC profiles (in their ICCdefined syntax) that convert a device-specific color to/from
the device-independent ICC Profile Connection Space (PCS).
Use*
Use the IPDS CMOCA instruction CC CMR. If no applicable CMR exist, the
IPDS uses the default User Destination Profile. If the User Destination Profile
option is set to Ignore or no User Destination Profile is present in the printer, the
IPDS uses a build-in output profile adapted for the specific printer model as the
default output profile.
Ignore
Ignore the IPDS CMOCA instruction CC CMR. The IPDS will use the default
User Destination Profile. If the User Destination Profile option is set to Ignore or
no User Destination Profile is present in the printer, the IPDS uses a built-in
output profile adapted for the specific printer model as the default output profile.
Refer to section 6 Color Management – User Files on page 65 for more information on uploading user
files.
Note: CMOCA feature is available on the following printers: Lexmark C950, Lexmark X950, X952,
X954, and Lexmark X548.
Note: CMOCA feature is available on the EC1.1 (and above) firmware releases of the following printers:
Lexmark C792, Lexmark C925, Lexmark X792, and Lexmark X925.
3.4.13 Remove User Files
This function is used for the removal of color management files uploaded by the user through the printer
web interface and stored on a disk, user flash or the flash of the IPDS Card.
If attempting to erase resources on a copy protected storage media, the operation will fail with a front
panel message to the user. Remove the password protection to allow removal of the files.
All
Remove all user files, stored on any media.
User CMYK Profile
Remove all user CMYK profile files.
User RGB Profile
Remove all user RGB profile files.
User Dest. Profile
Remove all user Destination profile files.
User HL Table
Remove all user Highlight Mapping Table files.
User OCA Table
Remove all user OCA Mapping Table files.