Lexmark X548 - 5 Finishing Support

48
5 Finishing Support
Finishing support includes offset stacking and stapling.
The table below shows the finishing support provided when an optional output bin is installed. The
finishing functions may not apply to all media sizes. When a function can not be applied to a specific
media, the job will print but finishing functions will not be performed. Refer to your printer
documentation for media size support of these functions.
Finishing functions for all products:
Function/
Support
Hole
Punch
Offset Stacking
Stapling
Staple
position
Maximum
Staple
Packet
Size*
Center
Fold**
Saddle
Staple**
Lexmark C792
Lexmark X792
Yes
1
Optional Finisher
Physical Bin 2
Optional
Finisher
Physical
Bin 2
Single
(Top
Left)
50 Sheets - -
Lexmark C925
Lexmark X925
Lexmark X548
- - - - - - -
Lexmark C950
Lexmark X950
Lexmark X952
Lexmark X954
Optional
Finisher
Physical
Bin 2
Standard Bin
(no HTU
installed),
Exit Tray 2
2
(no HTU
installed),
Second Exit Bin
3
(Top of HTU),
Optional Finisher
Physical Bin 2
Optional
Finisher
Physical
Bin 2
Single,
Dual,
Double,
Dual
4
50 Sheets Optional
Finisher
Physical Bin
3 (Advanced
Finisher
only)
Optional
Finisher
Physical Bin
3
(Advanced
Finisher
only)
Lexmark
6500e
- Optional Finisher Optional
Finisher
Single
(Top
Left)
50 Sheets - -
* Assumes 20 lb. plain letter sheets
** Two optional finisher units are supported. The Standard Finisher has two bins and does not
support Center Fold-in or Saddle staple (Saddle stitch-in). The Advanced Finisher supports all
listed finishing functions. Letter and A4 paper must be loaded Short Edge Feed (SEF) for Center
fold-in and Saddle stitch-in to be performed.
Note 1: Optional Finisher with optional hole punch unit installed in Horizontal Transport Unit (HTU).
When these options are installed holes may be punched in media directed to physical bin 1 and
physical bin 2.
Note 2: The supported printer only accepts the Exit Tray 2 when neither Finisher A nor Finisher B is
installed. When installed: 1) the printer uses the string “Bin 1” to refer to the Exit Tray 2 output
bin, and 2) the user must configure “Exit Tray 2” to “On” in order for the printer to recognize the
bin. Please refer to the printer’s manual for more information.
Note 3: When a finisher is attached, the Horizontal Transport Unit (HTU) occupies a portion of the
original standard bin; the original standard bin remains a usable, empty-sensing bin.
Note 4: Letter and A4 paper must be loaded Long Edge Fed (LEF) for Double Dual stapling to be
performed.