Lexmark X656DE - Page 106

2-72 Service Manual
7462
Go Back
Previous
Next
28x.61
x = bin
number
DMID command is not
received for 500ms
after main motor runs
Applies to:
StapleSmart finisher
A software failure has occurred
with the output option.
1. Turn the machine off/on.
2. Replace the output option if
problem remains.
28x.62
x = bin
number
When finishing job
isn't completed yet,
the first DMID
command of the next
job is received.
Applies to:
StapleSmart finisher
A software failure has occurred
with the output option.
1. Turn the machine off/on.
2. Replace the output option if
problem remains.
28x.63
x = bin
number
Bin clamp motor
control timer error.
Applies to:
StapleSmart finisher
A software failure has occurred
with the output option.
1. Turn the machine off/on.
2. Replace the output option if
problem remains.
28x.64
x = bin
number
Bin clamp motor
control timer error
during tray holder
initial.
Applies to:
StapleSmart finisher
A software failure has occurred
with the output option.
1. Turn the machine off/on.
2. Replace the output option if
problem remains.
28x.65
x = bin
number
Bin clamp home
position jam
Applies to:
StapleSmart finisher
The bin clamp home position is
not detected by the sensor (bin
clamp HP)
1. Turn the machine off/on.
2. Replace the output option if
problem remains.
28x.66
x = bin
number
Bin clamp home
position jam
Applies to:
StapleSmart finisher
The sensor (bin clamp HP)
does not detect that the bin
clamp has moved from home
position.
1. Turn the machine off/on.
2. Replace the output option if
problem remains.
28x.67
x = bin
number
Invalid bin clamp
manager state.
Applies to:
StapleSmart finisher
A software failure has occurred
with the output option.
1. Turn the machine off/on.
2. Replace the output option if
problem remains.
Error
code or
message
Error contents Description/Action Possible repair actions