Lexmark X656DE - Page 109

Diagnostic information 2-75
7462
Go Back
Previous
Next
290.03 Sensor (ADF sheet
through) lingering jam
Media reached the sensor
(ADF sheet through) but did
not clear it within the specified
time.
See “Sensor (ADF sheet
through) lingering jam
service check” on
page 2-116.
290.10 Sensor (ADF 1st
scan) static jam
Media remains on the sensor
(ADF 1st scan) during the
warm up sequence.
See “Sensor (1st scan) static
jam service check” on
page 2-118.
291.00 Sensor (ADF 2nd
scan) static jam
Media remains on the sensor
(ADF 2nd scan) during the
warm up sequence.
See “Sensor (2nd scan)
static jam service check” on
page 2-119.
291.01 Sensor (ADF 2nd
scan) late jam
The media does not reach the
sensor (ADF 2nd scan) within
the specified time.
See Go to “Sensor (ADF 2nd
scan) late jam service check”
on page 2-150
291.02 Sensor (ADF media
exit) late jam
The media does not reach the
sensor (ADF media exit) within
the specified time.
See “Sensor (ADF media
exit) late jam service check”
on page 2-124.
292.00 ADF top door open
jam
The ADF top door assembly
was opened while the ADF was
operating.
See “ADF top door open jam
service check” on
page 2-122.
293.00 Media missing jam The media is removed from the
ADF once the feed process is
initiated.
See “Media missing jam
service check” on
page 2-122.
294.00 Sensor (ADF media
exit) static jam
Media remains on the sensor
(ADF media exit) during the
warm up sequence.
See “Sensor (ADF media
exit) static jam service
check” on page 2-123.
294.01 Sensor (ADF media
exit) lingering jam
Media reached the sensor
(ADF media exit) within the
specified time but did not clear
it within the specified time.
See “Sensor (ADF media
exit) lingering jam service
check” on page 2-126.
294.03 Sensor (ADF media
exit) lingering jam
Media reached the sensor
(ADF media exit) within the
specified time but did not clear
it within the specified time.
See “Sensor (ADF media
exit) lingering jam service
check” on page 2-126.
840.01 Scanner manually
disabled
The scanner has been
manually disabled.
Enter the configuration mode to
re-enable the scanner.
840.02 Scanner auto
disabled
The scanner has automatically
been disabled by the controller.
Enter the configuration mode to
re-enable the scanner.
841.xx Scanner image
pipeline failure
The scanner image ASIC has
failed.
1. Check all connections on the
ADF controller card assembly.
2. Replace the scanner
controller card assembly if
problem remains.
Go to “Scanner controller
card assembly removal
(models X651, X652, X654
and X656)” on page 4-129 or
“Scanner controller card
assembly removal (model
X658)” on page 4-127.
Error
code or
message
Error contents Description/Action Possible repair actions