Repair information 4-231
7462
4-bin mailbox assembly sensor (pass through) removal
Note: The sensor (pass through) is the lower rear sensor. The rear upper sensor is the sensor (mailbox
empty).
1. Open the rear door.
2. Lift the deflector gate above the sensor (pass through) and using a flat-blade screwdriver, release the tabs
securing the sensor (pass through) to the 4-bin mailbox assembly.
3. Remove the 4-bin mailbox left cover. See “4-bin mailbox assembly left cover removal” on page 4-218.
4. Disconnect the sensor (pass through) harness from the controller board.
To Next Page
Loading...
