Lexmark X656DE - Page 80

2-46 Service Manual
7462
Go Back
Previous
Next
243.34 Empty tray pick
attempted
Source = Tray 3
The pick arm attempted to pick
with no media in the tray.
1. Check the media out
actuator for damage.
2. Replace the media out
actuator if problem
remains. Go to “Media out
actuator removal” on
page 4-23.
243.36 Sensor (pass through)
static jam
Source = Tray 3
Media remains on the sensor
(input) during the warm up
sequence.
Go to sensor (pass through)
static jam service check.
See “Sensor (pass through)
static jam service check” on
page 2-144.
243.37 Sensor (pass through)
late jam
Source = Tray 3
The media is late reaching the
sensor (pass through) within
the specified time.
Go to sensor (pass through)
late jam service check.
See “Sensor (pass through)
late jam service check” on
page 2-142.
243.39 Media tray pulled jam
Source = Tray 3
A media tray above the source
tray was pulled during the
printing process.
1. Remove all media present
in media path.
2. Close all media trays.
243.40 Sensor (pass through)
lingering jam
Source = Tray 3
Media reached the sensor
(pass through) within the
specified time but did not clear
it within the specified time.
Go to sensor (pass through)
lingering jam service check.
See “Sensor (pass through)
lingering jam service check.”
on page 2-143.
243.49 HCIT tray lift motor
stalled failure
Source = Tray 3
The HCIT tray lift motor has
stalled or has become
obstructed.
1. Ensure the HCIT media tray
assembly is properly inserted
into the machine.
2. Check the HCIT tray lift
motor assembly for binding or
damage.
3. Replace the HCIT tray lift
drive motor assembly if
problem remains.
Go to “High capacity input
tray (HCIT) tray lift drive
motor assembly removal” on
page 4-163.
243.50 HCIT tray lift motor
underspeed failure
Source = Tray 3
The HCIT tray lift motor does
not rotate at the specified
speed.
1. Ensure the HCIT media tray
assembly is properly inserted
into the machine.
2. Check the HCIT tray lift
motor assembly for binding or
damage.
3. Replace the HCIT tray lift
drive motor assembly if
problem remains.
Go to “High capacity input
tray (HCIT) tray lift drive
motor assembly removal” on
page 4-163
.
Error
code or
message
Error contents Description/Action Possible repair actions