Lexmark X850E - Page 101

101
Attendance messages
Scan Document Too Long The scan job exceeds the maximum
number of pages.
Note: The scanner finishes scanning current
pages in the ADF, but data is lost when the job
cancels itself after reaching the maximum
number of pages.
Touch Continue to clear the message.
Touch Cancel Job to clear the message if the
job is restartable.
Touch Restart job if the job is restartable. The
message clears, and a new scan job containing
the same parameters as the previous job starts.
Scanner ADF Cover Open The scanner automatic document
feed cover is open.
The message clears when the cover is closed.
Some held jobs were lost Occurs when the MFP tries to restore
all jobs on a hard disk regardless of
the number of held jobs not restored.
The message appears once.
Touch Continue to clear the message.
Some held jobs are not restored. They stay on
the hard disk and are inaccessible.
1565 Emul error, load
emulation option
The download emulator contained in
the firmware card does not function
with the MFP firmware.
Note: The MFP automatically clears
the message in 30 seconds and then
disables the download emulator on
the firmware card.
For help downloading the correct download
emulator version, contact the place where you
bought your printer.
31 Defective or missing
toner cartridge
A defective toner cartridge is detected
by the MFP, or the toner cartridge is
not installed.
Replace the defective cartridge with a new one,
or install the toner cartridge for printing to
continue.
32 Replace unsupported
toner cartridge
An unsupported toner cartridge is
installed.
Remove the toner cartridge, and install a
supported one for printing to continue.
34 Incorrect media,
check [src] guides
Several problems may exist.
• The MFP may not know the actual
print media size loaded in a tray
due to incorrect orientation.
• The tray or multipurpose feeder
guides may not be in the proper
location.
• The print media size loaded is
incorrect.
1 Open the tray.
2 Adjust the guides in the tray or the
multipurpose feeder.
3 Close the tray.
Touch Continue to clear the message and
continue printing.
Touch Cancel Job to cancel the current job if
needed.
Touch Reset Active Bin to change to another
linked bin.
35 Insufficient memory
to support Resource Save
feature
The MFP lacks the memory needed
to enable Resource Save. This
message usually indicates too much
memory is allocated for one or more
of the MFP link buffers.
Touch Continue to disable Resource Save and
continue printing.
Install additional memory.
37 Insufficient memory
for Flash Memory
Defragment operation
The MFP cannot defragment flash
memory because the memory used to
store undeleted flash resources is full.
Touch Continue to clear the message.
To perform the defragment operation, install
additional memory, or delete fonts, macros, and
other data to free some memory space.
Touch Reset Active Bin to change to another
linked bin.
Message Meaning Action