Lexmark X850E - Custom bin Names; Universal Setup

24
Paper Menu
Custom Bin Names
This menu item is used to define a custom name for each output bin based on a person or the type of print media assigned
to exit to a specific output bin.
Universal Setup
These menu items are used to specify the height and width of the Universal Paper Size. By specifying the height and width
for Universal Paper Size, the MFP uses the Universal setting like other paper sizes, including support for duplex and n-up.
For more information on n-up, see Multipage Print.
Menu item Purpose Values and descriptions
<user-defined
Custom Bin Name>
Specifies the custom name of output
bin <x> where x is 1–10 based on the
MFP model or the optional finisher, if
one is attached.
[user-defined
name], such as:
Company’s bin
Lawyer’s bin
Mary’s bin
Stephen’s bin
The custom output bin must be able
to accept the type of print media
assigned to exit to the defined bin to
assign a user-defined name.
Menu item Purpose Values and descriptions
Units of Measure Determines the unit of measure
used to enter the Universal Height
and Width.
Inches
Millimeters
Inches is the US default, and
Millimeters is the international default.
Portrait Width Sets the portrait width of the
universal media.
Note: If the value set exceeds the
maximum width, the MFP uses the
maximum value allowed in inches or
millimeters.
3 inches to 17 inches
in 0.01 inch
increments
76 mm to 432 mm in
1 mm increments
Shows either inches or millimeters
from Units of Measure setting;
11.69 inches is the US default, and
297 mm is the international default.
Portrait Height Sets the portrait height of the
universal media.
Note: If the value set exceeds the
maximum height, the MFP uses the
maximum value allowed in inches or
millimeters.
3 inches to 17 inches
in 0.01 inch
increments
76 mm to 432 in
1 mm increments
Shows either inches or millimeters
from Units of Measure setting;
17 inches is the US default, and
432 millimeters is the international
default.
Feed Direction Specifies the feed direction of the
Universal Paper Size.
Short Edge*
Long Edge
Feed Direction is only shown if the
Long Edge value is available. Long
Edge exists if the longest edge is
shorter than the maximum physical
width that the tray can accommodate.
See Duplex Bind on page 68 for
more information about short and long
edges.