Lexmark X850E - Page 55

55
Settings
Dial Prefix A numeric entry field is provided to
enter numbers. The previously entered
numbers are shown.
The dial prefix could be a country code
or a code businesses use to dial an
outside line.
Number string The entry field is limited to 16
characters. Text entry characters are
limited to:
0–9, (, ), ., +, -, and a space.
Automatic
Redial
Specifies the number of times the MFP
automatically tries to send the fax job
again by resubmitting the Fax To
number.
0–9 (5*)
Redial
Frequency
Select a range in minutes for the
number of redials to occur in that time
span.
1–200 (3*)
Behind a
PABX
Enables or disables switchboard blind
dialing without a dial tone.
Yes Do not wait for a dial tone.
No* Wait for a dial tone.
Enable ECM Enables Error Correction Mode for fax
jobs, which makes faxing more
reliable.
Yes* ECM is enabled.
No ECM is disabled.
Enable Fax
Scans
Allows sending faxes by scanning at
the MFP.
On* Fax scans are enabled.
Off Fax scans are disabled.
Driver to Fax Allows driver to fax jobs to be sent by
the MFP.
On* Driver to fax jobs can be sent.
Off Driver to fax jobs cannot be sent.
Driver to fax jobs are treated like
PostScript jobs.
Allow Save as
Shortcut
Allows for saving fax numbers as
shortcuts in the MFP.
Yes* A Save as Shortcut button appears on
the screen.
No A Save as Shortcut button does not
appear on the Fax Destination screen.
Dial Mode Specifies the dialing sound, either as a
tone or a pulse.
Note: This menu item may not be
available in all countries or regions.
Tone* A tone sounds for each number dialed.
Pulse A pulsating noise sounds for each
number dialed.
Custom Job
scanning
Allows for scanning of custom fax jobs.
This is also known as Job Build.
Custom Job is not supported on all
models.
On
Off*
To set to On, select the check box.
To set to Off, clear the check box.
Background
Removal
Adjusts the amount of background
visible on a copy.
-4 to +4 (0*) -4 sets Background Removal to off.
+4 sets Background Removal to the
maximum allowed.
Contrast Specifies the contrast used for the
scan job. The default is dependent on
the Content menu item. If the Content
menu item is reset from the default
setting, then the default for Contrast is
reset also.
0–5 Text default is 5.
The default is 0 for items other than
text.
Menu item Purpose Values and descriptions