Loading standard or optional 500-sheet trays
63
Printing
2 Squeeze the side guide tab, and slide the guide to the outside of the tray.
3 Squeeze the front guide tab, and slide the guide to the correct position for the media size you are loading.
4 Flex the sheets back and forth to loosen them, then fan them. Do not fold or crease the print media. Straighten the
edges on a level surface.
5 Load print media in the tray with the print side up.
For information about loading Letter or A4 size media in the short-edge feed position, see Loading Letter or A4
size print media in the short-edge feed orientation.
Note: Make sure the print media is below the max fill line on the rear guide. Overloading may cause jams.
To Next Page
Loading...
