Lexmark XM7163 - Page 14

• Flex the stack of envelopes back and forth to loosen
them, and then fan them. Straighten the edges on a level
surface.
5 Load the paper or specialty media.
Note: Slide the stack gently into the multipurpose feeder
until it comes to a stop.
• Load only one size and type of paper or specialty media at
a time.
• Make sure the paper fits loosely in the multipurpose feeder,
lies flat and is not bent or wrinkled.
• There are
dierent
ways of loading letterhead depending
on whether an optional staple finisher is installed or not.
Without an optional staple
finisher
With an optional staple
finisher
One‑sided printing One‑sided printing
Without an optional staple
finisher
With an optional staple
finisher
ABC
Two‑sided printing
ABC
Two‑sided printing
• If you are loading prepunched paper for use with the staple
finisher, then make sure the holes on the long edge of the
paper are on the right side of the tray.
One‑sided printing Two‑sided printing
ABC
Note: If the holes on the long edge of the paper are on
the left side of the tray, then a jam may occur.
• Load envelopes with the flap side down and on the left of
the multipurpose feeder.
B
5
E
X
EC
A
4
A
5
LTR
Warning—Potential Damage: Never use envelopes with
stamps, clasps, snaps, windows, coated linings, or
self
‑ stick adhesives. These envelopes may severely
damage the printer.
14