Lexmark XM7163 - Additional Printer Setup; Installing Internal Options

Additional printer setup
Installing internal options
CAUTION—SHOCK HAZARD: If you are accessing the controller board or installing optional hardware
or memory devices sometime after setting up the printer, then turn the printer o, and unplug the power
cord from the electrical outlet before continuing. If you have any other devices attached to the printer,
then turn them o as well, and unplug any cables going into the printer.
Warning—Potential Damage: Controller board electronic components are easily damaged by static
electricity. Touch a metal surface on the printer before touching any controller board electronic components
or connectors.
Available internal options
• Memory card
– DDR3 DIMM
– Flash memory
• Fonts
• Firmware cards
– Forms barcode
– PRESCRIBE
– IPDS
– Printcryption
• Lexmark
TM
Internal Solutions Ports (ISP)
– Parallel 1284-B interface
– MarkNet
TM
N8350 802.11 b/g/n wireless printer server
– MarkNet N8130 10/100 fiber interface
– RS-232-C serial interface
Accessing the controller board
Note: This task requires a
flat
‑head screwdriver.
Additional printer setup 27