85
2-1. Instrument cluster
2
Vehicle status information and indicators
The display is reset each time the engine is
started.
Press and hold “OK” of the meter control
switch to reset the record.
Peak hold function
When more than a certain amount of force
is applied, the G-force value display will be
retained for a few seconds.
■ G-force display
● The G-force values may not be zero even
when the vehicle is parked, such as when
it is parked on an incline.
● Depending on the vehicle usage condi-
tions, the brake fluid pressure display may
not reach its maximum reading even
though the brake pedal is fully depressed.
● If a battery terminal is disconnected and
reconnected, the steering amount display
may be disabled temporarily. After driv-
ing the vehicle for a while, the display will
be enabled.
Displays the current shift range or gear
position when the shift position is in D
or M.
Displays no drive information contents
on the multi-information display.
Fuel consumption information can be
displayed on the center display.
■ Displaying fuel consumption/his-
tory screen on the center display
1 Select on the main menu.
2 Select “Trip information”.
3 Select “Current” or “History”.
■ Current fuel consumption screen
Resetting the history data
Fuel consumption in the past 15
minutes
Current fuel consumption
Average vehicle speed since the
engine was started.
Trip range
Elapsed time since the engine was
started.
Use the displayed average fuel consump-
tion as a reference. The image is an exam-
ple only, and may vary slightly from actual
conditions.
■ History fuel consumption screen
Latest fuel consumption
Best recorded fuel consumption
Previous fuel consumption record
Resetting the history data
Gear Position
Blank (No items)
Current fuel consumption/his-
tory screen
To Next Page
Loading...
