268
4-5. Using the driving support systems
NX200t_OM_USA_OM78145U
● When the lane markers are on a curb, etc.
● When driving on a particularly bright road surface, such as concrete
● When driving on a road surface that is bright due to reflected light
● When driving in a location where the light level changes rapidly, such as the entrance to
or exit from a tunnel
● When sunlight or the headlights of oncoming vehicles are shining directly into the cam-
era lens
● When driving on roads that are branching or merging
● When driving on a hill
● When driving on winding roads or roads that are uneven
● When driving on rough or unpaved roads
● When driving on a sharp curve
● When lane markers are extremely narrow or extremely wide
● When the vehicle leans to one side an unusual amount due to a heavy load or improper
tire inflation pressure
● When the following distance between your vehicle and the vehicle ahead is extremely
short
● When the vehicle experiences strong up-and-down motion such as when driving on an
extremely rough road or on a seam in the pavement
● When headlight brightness at nighttime is reduced due to dirt on the lenses, or when
the headlights are misaligned
● When receiving a side wind
■ When changing the tires
Depending on the tires used, such as snow tires, etc., sufficient performance may not be
maintainable.
■ Warning messages for the LDA
Warning messages are used to indicate a system malfunction or to inform the driver of
the need for caution while driving. If a warning message is shown on the multi-informa-
tion display, read the message and follow the instructions.
Also, even if a warning message is displayed, it will not impede normal driving.
■ When turning on/off the steering control function
From “Settings display” (→P. 92) of the multi-information display, the steering
control function can be turned on/off.
Pressing the or meter control switches (→P. 92), selects
With each press of meter control switches, the control switches between “On” and
“Off”
■ Sensitivity adjustment for the lane deviation alert buzzer
From
“Settings display” (→P. 92) of the multi-information display, the alert sensi-
tivity for the alert buzzer when deviating from the lane can be adjusted.
Pressing the or meter control switches (→P. 92), selects
With each press of meter control switches, the control switches between “High”
and “Standard”
1
1
2
To Next Page
Loading...
Need help?
General
