478
6-4. Other interior features
NX200t_OM_USA_OM78145U
■ Enabling 2-way communication with a garage door (only available for com-
patible devices)
When enabled, 2-way communication allows you to check the status of the
opening and closing of a garage door through indicators in your vehicle.
2-way communication is only available if the garage door opener motor used
is a compatible device. (To check device compatibility, refer to www.Home-
Link.com.)
Within 5 seconds after programming the garage door opener has been
completed, if the garage door opener motor is trained to HomeLink
®
,
both garage door operation indicators will flash rapidly green and the light
on the garage door opener motor will blink twice, indicating that 2-way
communication is enabled.
If the indicators do not flash, perform and within the first 10 presses of
the HomeLink
®
button after programming has been completed.
Press a programmed HomeLink
®
button to operate a garage door.
Within 1 minute of pressing the HomeLink
®
button, after the garage door
operation has stopped, press the “Learn” or “Smart” button on the garage
door opener motor. Within 5 seconds of the establishment of 2-way com-
munication with the garage door opener, both garage door operation indi-
cators in the vehicle will flash rapidly green and the light on the garage
door opener motor will blink twice, indicating that 2-way communication is
enabled.
■ Reprogramming a single HomeLink
®
button
When the following procedure is performed, buttons which already have
devices registered to them can be overwritten:
With one hand, press and hold the desired HomeLink
®
button.
When the HomeLink
®
indicator starts flashing orange, continue to hold
the HomeLink
®
button and perform “Programming HomeLink
®
” (it
takes 20 seconds for the HomeLink
®
indicator to start flashing).
Press the appropriate HomeLink
®
button. The HomeLink
®
indicator light
should turn on.
Operating the HomeLink
®
2
To Next Page
Loading...
Need help?
General
